Quote:
Originally Posted by jman
Hi, thanks for your feedback.
After a couple more tries this is what I discovered.
There are two different issues:
1) When I load the debugger from the editor pressing CTRL+D, the machine raises this software error 8000 0004. No instruction is actually run into the debugger yet. I just have a glance of the debugger window for two seconds before the software error is triggered.
2) If I launch directly MonAm from WB, the screen goes into an unknown screenmode but I can blindly press CTRL+C and be back to WB.
For the moment I'd be glad to first solve point 2.
Can you (or anyone reading this post) tell me which screenmode MonAm sets? I noticed I have the same problem (point 2 of the above) when launching AsmOne. How can I solve? Do I need a SD/FF?
I never noticed these problem under WinUAE. Is it possible that an RTG card could solve?
Thanks!
|
IIRC it's 640*256 might be 640*200 for NTSC. The MonAm I was using is 3.06 I read again the review I made back then and older version of MonAm crashed on 68040. Kamel