View Single Post
Old 10 July 2012, 08:15   #3
Spirantho
Registered User
 
Join Date: Jul 2012
Location: Aberystwyth, Wales
Posts: 16
in this case I feel sure the unreliable component is the user. Of course I know how to do it properly now, but it's a bit late.

I think I measured down to 4.7V at one point, which seems very low. I reckon the next thing to do is to take off all the 47uFs and re-do them with through-holes from the nearest solder points, rather than try to use SMTs where a track has lifted.....

Thanks for the advice, I think it's a low voltage problem. Would low ESR caps help?
Spirantho is offline  
 
Page generated in 0.05156 seconds with 11 queries