English Amiga Board - View Single Post

FicHitA · 19 December 2018, 20:31

Just bought a Wicher 500i rev 2a and I have the following problem, when i boot the A500 the wicher starts and the memory is allocated but the IDE is not working

After checking with the FORMAT command a CC0: unit of 20k in size appears, it appears if i connect and IDE or not. (i connect a IDE2SD with a 4Gb SD card)

There is no MOUNTLIST in devs so that CC0: must comes from somewhere... i continue checking and the CC0: unit is gone only if i set IDE OFF, but i need the IDE ON to make my disk work

Any help ?

19 December 2018, 20:31	#1
FicHitA Registered User Join Date: Dec 2018 Location: Argentina Posts: 16	Wicher 500i rev 2a IDE problem Just bought a Wicher 500i rev 2a and I have the following problem, when i boot the A500 the wicher starts and the memory is allocated but the IDE is not working After checking with the FORMAT command a CC0: unit of 20k in size appears, it appears if i connect and IDE or not. (i connect a IDE2SD with a 4Gb SD card) There is no MOUNTLIST in devs so that CC0: must comes from somewhere... i continue checking and the CC0: unit is gone only if i set IDE OFF, but i need the IDE ON to make my disk work Any help ?