View Single Post
Old 29 March 2009, 00:17   #1
kipper2k
Registered User

 
Join Date: Sep 2006
Location: Thunder Bay, Canada
Posts: 3,959
NTSC A500 Pal/NTSC mod pics

Hi all

i figured it was time to mod my NTSC A500 (V5) for multiregion boot so here it is...



I ran the wires to a jumper block so i can use a regular 2 pin female header block with a switch on it to toggle the modes and also allow unplugging etc. I haven't decided where i am going to mount the switch yet.

I just broke off the pin on the chip and then bent the socket wire back over the socket and then soldered the wires on to each side of the jumper block

Last edited by kipper2k; 29 March 2009 at 00:25.
kipper2k is offline  
 
Page generated in 0.04706 seconds with 11 queries