View Single Post
Old 16 December 2019, 17:21   #9
a/b
Registered User

 
Join Date: Jun 2016
Location: europe
Posts: 180
Well, that's a different picture than the one in the first post.

In any case, you wouldn't have do draw that line if you were using the FCI bit. When you are doing filled poly clipping, you normally draw a vertical line on the right-hand border when a line-segment is >= width, because blitter works right to left, and skip the left-hand border entirely (don't draw anything when < 0). So you just either change your poly-clipper to optionally skip those lines, or make two routines if performance is an issue.
Or is there another 'hidden' constraint?
a/b is offline  
 
Page generated in 0.04304 seconds with 11 queries