View Single Post
Old 05 November 2018, 08:26   #25
supaduper
Registered User
supaduper's Avatar
 
Join Date: Oct 2012
Location: Birmingham UK
Posts: 901
The large holes being ground planes have a bigger mass to heat up to soldering temp whereas the pins on the jack are a smaller ground plane mass so heat up quicker than the holes,so the solder is sucked up by the smaller hotter ground plane first.

So either you are using an insufficient soldering iron temp or tip I.E better to use a higher soldering temp with a bigger iron tip like a broad chisel tip a normal point fine tip will never work
supaduper is offline  
 
Page generated in 0.04778 seconds with 11 queries