[paul1981]

Originally Posted by klx300r

when adding PFSaio to OS3.1.4 HDToolBox a requester pops up asking with following 'default values'&lt;br /&gt;<br />
&lt;br /&gt;<br />
Enter DataType for File System:0x444FS5303&lt;br /&gt;<br />
Enter version: 19&lt;br /&gt;<br />
&lt;br /&gt;<br />
enter revision: 2&lt;br /&gt;<br />
&lt;br /&gt;<br />
&lt;br /&gt;<br />
when hitting ok it says file system already exists...it appears default setting for this screen is same as FFS ? quick Yahoo search and I see figure should 0x50465303 but would love to have this confirmed as I want to get this right the 1st time and not go through deleting/ reformatting stuff afterwards...same goes with block size/ buffers

Regarding the buffers, set to 300 if you have the full WHDLoad games set installed, but only for the drive that the games are stored on. If you have a seperate boot drive, 70 buffers or less will be fine for the boot (70 was the old PFS minimum setting, so stick with 70 to be safe; although now with the later versions it's supposed to be safe to use any figure below 70).