View Single Post
Old 14 May 2020, 18:19   #17
Toni Wilen
WinUAE developer
 
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 45
Posts: 24,047
I did say DirectDraw is unsupported

Try using D3D mode, then select native resolution (non-native ones may not work as you expect, unless you used display driver control panel to create them), then use filter options to scale it to fullscreen. Trying to match Amiga internal resolution to PC monitor resolution is bad idea with modern displays. Monitor internal scaling usually sucks.

Start also with as basic as possible setup = A500 config.

Quick setup:

- D3D11 (or D3D9)
- Fullscreen. Select your display native resolution, 50Hz.
- Set filter panel scaling multipliers to get fullscreen image (you don't need to care if it isn't perfect fit, it isn't perfect in real world either, set aspect also to automatic, you probably don't have 4:3 display..)

If scrolling etc.. looks ok, enable lagless vsync and check again.
Toni Wilen is offline  
 
Page generated in 0.04597 seconds with 11 queries