View Single Post
Old 25 August 2014, 21:16   #1
Leffmann
 
Join Date: Jul 2008
Location: Sweden
Posts: 2,265
Sensible volume names for ADF as HD

When mounting an ADF as an HD, would it be possible to give it the same volume name as the disk, instead of the actual name of the ADF file?

I just installed Workbench 3.1 and BetterWB, and swapping the disks is tedious, but if you could just drop all 10 disks into the hard drives and have them mount with their actual volume names, then you could run through the whole installation nice and fast.

Also, would it be possible to have the debugger display the actual instruction that causes a break, instead of the next one? The debugger always displays the next instruction to execute, which is inconvenient because you have to step back 2 bytes at a time until you see the instruction that actually caused the break, and if it was a branch then you have no idea where it came from.
Leffmann is offline  
 
Page generated in 0.04134 seconds with 11 queries