View Single Post
Old 14 June 2018, 21:47   #17
Toni Wilen
WinUAE developer
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 43
Posts: 22,219
RDB/Full drive mode + ticking "Manual geometry" checkbox and adjusting block size should change drive's "physical" block size value. (=if it is 1024, SCSI READ would return 1024 bytes if number of blocks is 1 and so on..)

If RDB mode and emulated hardware controller: it adjusts "real" drive geometry/block size. If non-RDB: it adjusts partition's geometry and block size. (If non-RDB + emulated harddrive controller: broke >512 filesystem block size partitions because it previously adjusted both).
Toni Wilen is online now  
Page generated in 0.04088 seconds with 11 queries