Cheers for the help guys.
check4gb - version 1.4 (current config)
Code:
Name Volume Size Device Unit Version Type Version >4GB Check
SDH0 AOSTemp 4013M 2nd.scsi 2 40.13 CFS0 1.273 no ok
LDh0 AmigaOS3.9 2078M scsi 0 43.43 DOS5 45.13 no ok
LDH1 SuperStore 16GB scsi 0 43.43 CFS0 1.273 yes ok
The SDH0 partition is a 4013MB partition of a 20GB SCSI 2 SCA device - this device was setup under ClassicWorkbench 3.9 running from a 20GB IDE HDD -
The 20GB IDE drive was setup under WinUAE - with large disk support installed. I have used this drive for setting up other setups - like my 36.1GB SCSI disk on my CSMk2 CyberSCSI II.
of which my 36.1GB SCSI setup for 4 paritions on my CyberSCSI Mk2 is prepared for 2GB OS / 8GB Games / 8GB Applications / 8GB Dev / 8GB Store - when put on the A4091 it can only see the first 2GB partition - nothing else..
Trying to access it via CLI claims "there is not enough memory to access this device"
check4gb - version 1.4 (extra partition added SDH1)
Code:
Name Volume Size Device Unit Version Type Version >4GB Check
SDH0 AOSTemp 4013M 2nd.scsi 3 40.13 CFS0 1.273 no ok
SDH1 13G 2nd.scsi 3 40.13 CFS0 1.273 yes *
LDh0 AmigaOS3.9 2078M scsi 0 43.43 DOS5 45.13 no ok
LDH1 SuperStore 16G scsi 0 43.43 CFS0 1.273 yes ok
now even though HDToolsBox was able to see and partition SDH1: (13GB) its not mounted - and not accessable in workbench - thus I cannot format it.
under CLI
Code:
>check4gb 2nd.scsi.device
>2nd.scsi.device does not support greater than 4GB hard drives
>
At this juncture I am assuming that I need to patch 2nd.scsi.device - how does one patch 2nd.scsi.device for greater than 4GB support?