View Single Post
Old 15 October 2019, 05:07   #20
Registered User

Join Date: Nov 2014
Location: NSW/Australia
Posts: 316
Are you trying to use the IDE interface on the A2091 with a CF card? If so it won't work:

A little-known and mostly-unused function of the A2091 is a built-in XT-IDE controller. The IDE connector and LED are not installed, but visible on the board to the left and upper-right of the SCSI chip. Unfortunately, this port will only work with 8-bit (XT) IDE hard drives, not the common 16-bit AT-IDE hard drives. This option was apparently mostly used for the 20M drives supplied with the A590, the A500 hard disk option which shared the 2091 design.
(from here

Or if is the IDE interface on a separate card (in which case might be issues with scsi.device compatibility).
dalek is offline  
Page generated in 0.04114 seconds with 11 queries