View Single Post
Old 27 May 2018, 20:17   #38
kolla
Banned
 
Join Date: Nov 2007
Location: Trondheim, Norway
Posts: 1,899
Quote:
Originally Posted by systmcrsh View Post
'vcontrol fp 0' disables the fpu fine in 2.8, but when i run it with 2.9 the fpu is still active and still shows up in sysinfo.
On both my Vampires (V500-V2 in CDTV, and V600-V2), with core 2.9, any form of "software reboot", including "vcontrol fp 0", do not reboot the systems, but rather send them to a state where they refuse to boot again, as if they are in a forever search for boot disk or something. So yeah, I find myself unable to properly disable the FPU, as a full reset just brings it back.
kolla is offline  
 
Page generated in 0.04069 seconds with 11 queries