View Single Post
Old 31 January 2016, 01:43   #7
intric8
AmigaLover

intric8's Avatar
 
Join Date: Jan 2016
Location: Seattle, WA USA
Posts: 50
Well, that didn't work unfortunately.

I fired up HDToolBox and changed the max transfer rate for both DH1 and DH0. Previously, the rates were set to 0xfe0000. I did as you suggested and switched both to 0x1fe00. Pressed 'Enter' before clicking OK. I even rebooted and went back in to confirm the settings held, which they did.

But launching Syndicate still produces the same error.

I should also mention that I've got 2 sets of Syndicate install disks. They both do the same darn thing. I hear you guys with WHDLoad - trying to get it to work off the original disks, and I'm really scratching my head on this one. Both sets install all the way through with no issues. Just for fun I tried to launch using French instead of English, but it didn't make a difference.

Last edited by intric8; 31 January 2016 at 02:05.
intric8 is offline  
 
Page generated in 0.03986 seconds with 11 queries