View Single Post
Old 13 November 2008, 10:25   #4
EvilCensor
A1000 User
EvilCensor's Avatar
 
Join Date: Oct 2008
Location: London, England
Posts: 47
Send a message via MSN to EvilCensor
Okay I was more persistant with the acetone np remover and soaked the areas for longer periods - this softened it more and I'm gently scraping the substance off.. gonna take a few applications.

Not sure how to remove that other heatsink - any ideas?

Also does anyone have suggestions as to a better way of holding these heatsinks (if they are adequate) in place.. the fan connected atm is 2 cm2 (DC12v 1.1W).

As said before I've never had any issue with this card - even with on of the (as it turned out) loose heatsinks, but was this just good fortune?

(thanks for the advice so far - much appreciated)
EvilCensor is offline  
 
Page generated in 0.04060 seconds with 11 queries