View Single Post
Old 21 November 2017, 10:55   #11
A10001986
Registered User

A10001986's Avatar
 
Join Date: Jun 2017
Location: Vienna / Austria
Posts: 24
I am running this very hardware configuration in three A3000s without a problem; however, I needed to run "SCSIPrefs" to enable a long boot delay, otherwise the SCSI Controller would not see the drive. Warm boots never were a problem, happened only during cold start.

IIRC I did not set the "delay" jumper. Interesting to see that adding a delay seems to have the same effect.... (perhaps that jumper causes the scsi-response to be delayed so that the controller gives the drive more time to boot up...)

As a sidenote, speed will increase massively with "synchronous" mode enabled.
A10001986 is offline  
 
Page generated in 0.04137 seconds with 11 queries