View Single Post
Old 13 December 2019, 11:25   #2
katarakt
Registered User

 
Join Date: Jul 2017
Location: Germany
Posts: 155
The problem is you're using an elec&eltec powersupply in combination with this fan. This power supply needs a fan with a minimum consumption of around 0.7+ watts and the noctua has a lower power consumption...therefore the powersupply switches into protection mode.

You have to solder a 270 ohms/2 watts resistor in paralell to the fan connector and it will work! I've done this with a blacknoise M8-S1 with 0.36 watts and it's working excellent. Your noctua will work too if you're going to solder the resistor.

Last edited by katarakt; 13 December 2019 at 14:45.
katarakt is offline  
 
Page generated in 0.04393 seconds with 11 queries