View Single Post
Old 15 September 2017, 15:56   #33
Sinphaltimus
Registered User

Sinphaltimus's Avatar
 
Join Date: Aug 2016
Location: Cresco, PA, USA
Age: 49
Posts: 1,110
Yeah, I can't use my dremel - the metal is hard and thick. I tried. Very slow and stressful on the dremel. I'm using an industrial grinder w/cutting wheel. But thanks for the tip. I'm sure I'll use the dremel where it counts. Or perhaps you were referring to the plastic cutting I did? I should have thought of that. But I plan to fix the non straight edges with a belt sander for the faceplate and logo.

As for the PSU - following what this guy did - [ Show youtube player ]

Last edited by Sinphaltimus; 15 September 2017 at 15:56. Reason: fixed typos.
Sinphaltimus is offline  
 
Page generated in 0.04375 seconds with 11 queries