Quote:
Originally Posted by emux
Just for reference, my ACA1221 is running at full speed (28mhz) for the last few days in a standard 1200 case and I've not had any problems or lockups with it at all.
|
Like I wrote: The voltage from the power supply makes a big difference: 0.1V too high, and you'll have too much heat for overclocking. There's a small potentiometer in A500/A1200 power supplies where you can adjust the voltage. However, you should only open a power supply if you have the education and tools to work on high-voltage equipment. If you don't, please don't put your life in danger!
Quote:
Originally Posted by CrashMidnick
Working fine here on A1000 with ACA500 straight out of the box
|
...until you try to run the ACA1221 software! That's the part that does not work yet. We're working on a flash update for the ACA500 that will make the ACA1221 tools compatible. For the record: Don't set the trial jumper on the ACA1221 before we have the ACA500 flash update. You will lose valuable trial runs, and it won't work yet!
Jens