I'm still seeing the reset loop though. Even with the config I attached above, but changing CPU to cycle-exact 68000 (non-JIT of course).
There are lines like these in the log output (2014-02-14 17:58 winuae.exe):
Illegal instruction: 4e7b at 00F80C38 -> 00F80CC0
Illegal instruction: 00ff at 00A00100 -> 00F80AD2
Testing the 68000 config with 2.7.1b7 caused WinUAE to crash with this log output:
Code:
..
Illegal instruction: 4e7b at 00F80C38 -> 00F80CC0
Fastcard: mapped @$200000: 8MB fast memory
Card 1 (ZorroII) done.
A590/A2091 BOOT ROM '.\a2091PDMA-07.U12'
ExceptionFilter Trap: 00000016 38EBD4D8 00000000
D0 00000000 D1 00000020 D2 00000020 D3 00000000
D4 00000000 D5 00000000 D6 FFFFFFFF D7 00000000
A0 00E80048 A1 00000B6C A2 00E80000 A3 00000C00
A4 00E80000 A5 00000758 A6 00000A74 A7 000003B0
USP 00000000 ISP 000003B0
T=00 S=1 M=0 X=0 N=0 Z=0 V=0 C=0 IMASK=7 STP=0
Prefetch 7000 (MOVE) 1081 (MOVE) Chip latch 00000000
00FBD4D8 1081 MOVE.B D1,(A0)
Access violation! (68KPC=00FBD4D8 HOSTADDR=00000016)
delayed exception2!
ExceptionFilter Trap: 00000016 38E80000 38EBD4D8
wine: Unhandled page fault on read access to 0x00000016 at address 0x792b23 (thread 0009), starting debugger...