View Single Post
Old 03 October 2010, 23:09   #10
source
Zone Friend
 
Join Date: Jul 2005
Location: Toronto, Canada
Posts: 703
What I am doing is I have taken a usb 4 port hub, and took it a part. I removed the external power coupler and soldered a cut down internal power extension for internal drives and soldere the 5 volt and ground to the ush board. This was you are drawing power directly from the power supply not the deneb. I will be ordering 2 usb to pin header cables when I get around to it then plig those into the usb hub. I have not finished but that is the plan.
source is offline  
 
Page generated in 0.04151 seconds with 11 queries