View Single Post
Old 04 June 2010, 00:31   #9
Registered User

Foul's Avatar
Join Date: Jun 2009
Location: Perigueux/France
Age: 45
Posts: 1,467
Send a message via ICQ to Foul Send a message via MSN to Foul
Originally Posted by 8bitbubsy View Post
You should try to beep it with a multimeter to make sure there is good contact. It might boot without it, so have that in mind.
One multimeter pin at the cap's pad, and another at the underside of the mobo (where the hole is)
Every capacitor replaced was tested with a multimeter it's not my first attempt to repair PCB, i'm administrator of, a site concerning jamma Boards ... got plenty of them .. and repairing them in my spare time

The red substance is in fact hot glue ... just because some cap are moving .. not much ... much i don't like that ... so a little hot glue between motherboard and cap and nothing move... and just for information .. there is a slim dvd-rom drive just above this caps .. so there are some minimal vibrations .. not much but there are
Foul is offline  
Page generated in 0.05116 seconds with 11 queries