View Single Post
Old 12 February 2016, 11:02   #8
Matteo76
 
Posts: n/a
...You could use the cable from the CDTV and solder it to the new fan.

Sorry if i disturb you again...

So , i need only to cut and solder the 2 main power cable with the respective cdtv cable and exclude the 3rd sensor cable on the new fan (cause i have only 2 cable)?

Is the sensor cable supported by CDTV mainboard, cause i notice however a free third pin on the old fan connector.
 
 
Page generated in 0.04518 seconds with 10 queries