|
i dont think those wires are supposed to be there at all mate...
if you have a multimeter the pins they are connected to are directly connected to the pins to the left of them on the gary socket as gary is flipped over on its back,shine a torch through the pcb you should see what i mean,or better still post a clear picture within the thread and i will mark the pins for you in the picture itself.
the wires should not be there...as far as i know.
and the card has a passthrough for a 512kb card to go on the end,older ones had 1.5mb onboard already and the 512kb card had the disable switch on it.
the multimeter should be set to diode test or ohms at least,the result of the test should be a short at 0 ohms.
those pins should already be connected to pins 2 and 3 of the gary socket on the motherboard through the adaptor if that helps.where the wires are it should already be a direct link between pins 2 and 3 on gary to the socket on the motherboard if that makes it any clearer.well...should be.
just out of interest,did you ask the person who sold it to you?
|