View Single Post
Old 22 September 2007, 12:12   #10
Calgor
(Amigas && Amigos)++

Calgor's Avatar
 
Join Date: Sep 2005
Location: Anrea
Posts: 998
Bit confused, your initial description says it doesn't boot after reset, but your second description says it only won't boot after cold boot (reset button works)?

With 3.1, make sure you are using the A4000T specific install disks, as it does not boot into workbench without the workbench.library in libs: dir on the hard disk.

Also, I had to insert an echo line in the startup-sequence before SetPatch on OS3.9 otherwise it would remain a black screen (due to Picasso iv perhaps).

Suggest you get 3.1 working properly before going to 3.9, as it is less complicated.

About FFS on the hard disk RDB, you did say that you have FFS there, but you did not say which version. I have seen OS3.9 not boot without the correct version there.
Calgor is offline  
 
Page generated in 0.04163 seconds with 11 queries