View Single Post
Old 10 May 2017, 22:02   #586
demolition
Unregistered User
demolition's Avatar
 
Join Date: Sep 2012
Location: Copenhagen / DK
Age: 38
Posts: 3,598
USB to serial sounds right. It needs to have Rx, Tx, Vcc and Gnd pins. Look on ebay for 'rs232 serial ttl usb' and you will see some choices.

That display should also be fine. It doesn't need a display, but it is very useful. Note that to use the modes that uses the display, you also need to add another button since the existing two is not enough to navigate properly. It is just a button with two wires that is soldered to some pads on the Gotek.

The HxC firmware supports Amiga, Atari and PC so if your synth can use PC drives, then I think it should work.
demolition is offline  
 
Page generated in 0.03943 seconds with 11 queries