View Single Post
Old 18 March 2011, 00:31   #4
Hewitson
Registered User
Hewitson's Avatar
 
Join Date: Feb 2007
Location: Melbourne, Australia
Age: 37
Posts: 3,575
Using a capacitor rated for higher voltage will cause no problems whatsoever.

Resistor wattage can easily be determined by looking at the size of the resistor, however unless they look burnt it's very unlikely replacing them is going to be of any benefit.

Personally I think you're going about this the wrong way. A much better way to start troubleshooting the board would be to get a logic probe onto it and verify all the necessary signals are present and doing what they should be.
Hewitson is offline  
 
Page generated in 0.04154 seconds with 11 queries