View Single Post
Old 26 April 2006, 14:44   #18
chaoticjelly
Registered User
 
Join Date: Jun 2005
Location: UK - Lancs
Age: 34
Posts: 80
I tried the procedure as described on the DOOM faq, swapped lines 5 and 7 at the control pad PCB (I found out which points were 5 and 7 by putting a little bit of wire in the part of the 9 pin socket that corresponded to 5, and then pressing multimeter on end of wire, and then other prong of multimeter on pcb points for data and testing for continuity.. and same for 7.

I swapped the two and bridged them with a 470 ohm resistor.

My CD32 kept resetting when certain buttons was pressed, and kept moving up and down of its own accord..

Conclusion : the mod does not work.. perhaps its only for DOOM on an A1200??? (after all, it is a DOOM faq)
chaoticjelly is offline  
 
Page generated in 0.04501 seconds with 11 queries