|
Sorry, its getting late.
In winuae i have quite a few WB`s setup for this kind of occurance. I have a fresh WB3.0 plain. I also have a fresh WB3.0 with picasso installed. I also have AIAB, and then after joining this board i found out about ClassicWB. I now have all of those as well!!
Both versions of skidmarks run fine on every setup except Classic WB
The 2 versions of Skidmarks are:
1. Skidmarks 2.1 installed from the original disks which i copied to PC from my real A1200 before it broke.
2. Cd32 HD install version downloaded from BTTR this evening.
After taking your advice and running snoopdos, everything goes well until the following lines:
[4] execute open T:command-00-T04 read ok
[4] exceute open T:command-00-T04 write ok
It goes no further & then get the guru whilst stll on the WB screen
When running the game on a plain WB3.0, the next line when the game loads properly should be:
ramlib load LIBS:mathtrans.library ok
Ater which all the cars,tracks etc. are listed and the game then loads.
Hope this makes sense to someone.
Mark
|