Quote:
I was using:
Image: 8: 16GB: HDF RDB, DH0 (500MB PDS\03), DH1 (13.7GB PDS\03)
Workbench Adf Set: 'Workbench 3.1 Cloanto Amiga Forever 7' (6/6)
Kickstart Rom Set: 'Kickstart Cloanto Amiga Forever 7/2016' (5/5)
Install Packages: 'BetterWB v4.0.3, HstWB v1.1.2, EAB WHDLoad Demos OCS Menu v3.0.0, EAB WHDLoad Games OCS Menu v3.0.0, HstWB Mini v1.0.0'
Emulator File: 'WinUAE 3.6.1.0 32-bit
|
Ah, HstWB Mini v1.0.0 explains DH1 disappearing. The release in v1.2.0-BETA3 removes automount from DH1:, which means its only available using mount DH1: command. It was also quite differently from the other WB setup and had some not optimal configurations. These have been corrected in v1.2.0-BETA4.
HstWB Mini is my attempt to build a limit memory usage WB setup using a few tricks to maximize chip mem. One of them is to remove automount from DH0: partition, which uses chip mem for PFS3AIO or FFS 45.16 partitions for unexpanded Amigas. DH1: partition then becomes the boot partition and at the same time its typically the largest partition perfect for low mem Amiga with only one large partition available suitable for WHDLoad. The DH0: partition which is no longer automounted during boot, is still available through the Amiga Boot Selector menu selecting Workbench. It mounts the partition and moves system assigns and boots Workbench from DH0:.
HstWB Mini is also intended for the image template "4gb_hdf_rdb_dh0-100mb-dos7_dh1-3.4gb-dos7.zip" as it uses less chip mem than PFS3 for unexpanded Amigas that doesn't have fast mem.
I will build a new self install image based on that image template and just the packages that makes sense for low memory Amigas without chip mem.