View Single Post
Old 04 June 2018, 10:28   #2
thomas
Registered User
thomas's Avatar
 
Join Date: Jan 2002
Location: Germany
Posts: 5,731
Return code 10 just means "error". There is no specific meaning of this code.

There might be a reason code stored in dos.library. Try to enter "why" at the command prompt, just after the error.

Also search the startup-sequence script for any occurence of ">NIL:" and remove all of them. Then you might get a more meaningful error message.

Why do you need a floppy image? A properly configured CyberstromPPC can boot directly from the CD.

Make sure that the CD drive is connected to one of the supported controllers, i.e. the IDE port of the A4000 or the SCSI bus of the CSPPC. (To boot from CD it must be connected to the CSPPC SCSI.)
thomas is offline  
 
Page generated in 0.04129 seconds with 11 queries