Quote:
Originally Posted by FOL
I got same problem with A4000T. I bent a few pins in 3 Zorro slots, they ended up slapping off.
I ended damaging print and now no cards are recognized.
It was all the pulling cars in and out that caused my issue.
Id check the daughter board connector.
Where you say you put a card into the riser, you dont mean without the daughter board? If so, thats not a good idea.
|
I checked all the pins, everything looks good. Cleaned contacts as best I could with some Isopropy Alcohol...still no luck
I don't know why it doesn't work