View Single Post
Old 12 February 2017, 16:02   #19
Spacemonkey
Registered User

 
Join Date: Apr 2016
Location: Rochdale
Posts: 81
General tidy up
  • Replaced the original D-Sub 9 pin port extender cable with shorter cables and new adapters.
  • Mounted the Gotek to the case
  • New longer VGA cable to fit in the case rear D-Sub panel
  • Added HDMI D-Sub Panel adapter (For the Vampire)
  • Added Lycom ST-173-7 mSATA SSD to 2.5" IDE
  • USB to Panel mount











Lycom ST-173-7

FEATURES
  • Convert Full Size mSATA SSD to 44Pin 2.5” High Performance, No Noise, Low Power IDE SSD
  • Supports SATA I, SATA II and SATA III (6Gbps) mSATA SSD
  • Latch type mSATA connector on board, no need the screw for the retention of mSATA SSD
  • 100% Compatible with 2.5” IDE drive mechanical spec
  • 48 bits LBA can Break Capacity-Limit to Support mSATA SSD max 144,115,188GB
  • Compliant with Serial ATA 2.6
  • Jumper setting support IDE Master, Slave and Cable Select Modes
  • Tag Command Queuing (Max 32 entries)
  • ATA/ATAPI PIO mode data transfer
  • ATA/ATAPI UDMA data transfer rate of 150, 133, 100, 66, 44, 33, 25, 16.7 MB/s
  • ATA/ATAPI-7 Streaming feature set
  • Transparent to the operating system and no driver required
  • Supports any OS like Windows, Mac and Linux
  • Includes 7mm height 2.5 “ drive metal frame with 8 mounting holes and 4 HDD screws
  • Dimension of PCBA with 2.5” frame : 98mm x 69.85mm x 7mm
  • Fully RoHS compliant

Last edited by Spacemonkey; 23 February 2017 at 23:29. Reason: added some extra photos and details about Lycom ST-173-7
Spacemonkey is offline  
 
Page generated in 0.04249 seconds with 11 queries