View Single Post
Old 26 January 2006, 17:01   #4
jmmijo
Junior Member
jmmijo's Avatar
 
Join Date: Jan 2002
Location: PDX
Age: 57
Posts: 2,373
Perhaps if you look at the Form Factors site you can get all the info you need on how to do this. Please note section 3.3.2 and the PS_ON# signal, this is an active low signal that tells the power supply unit to turn on from idle or standby mode.

Then go to page 36 to view the main ATX power connector, note the PS_ON# signal pin and any ground pin. Just use an old reset or power switch from a PC chassis, the momentary on kind of switch, to connect them up and there you go
jmmijo is offline  
 
Page generated in 0.04433 seconds with 11 queries