View Single Post
Old 06 April 2012, 21:18   #1
4am
 
Posts: n/a
PCMCIA fault: DOS error code 225 - Not a valid DOS disk

Hi,

Newbie(ish) user looking for some advice - hope someone more learned can help!

A year or so ago I picked up an A1200 and a PCMCIA kit from amigakit. I managed to install everything ok and all was working fine.

This week I booted up the Amiga again having not used it for several months and once again, all was well. I've managed to copy some adfs and transfer to floppy via EasyADF just fine.

However upon rebooting the Amiga this afternoon - having used it fine for several hours - I'm getting an error when trying to read the contents of the PCMCIA card. The card is reading 'CF0:NDOS' in Workbench and when trying to view in Opus is giving the above '225' error message.

The CF card I'm using is a 2GB SanDisk Ultra II. I've tried reconnecting the card to the PCMCIA adapter but to no avail.

Any thoughts? Thanks in advance for any help.

Last edited by 4am; 06 April 2012 at 23:15.
 
 
Page generated in 0.04010 seconds with 11 queries