View Single Post
Old 05 January 2015, 22:29   #14
spudje
Registered User

 
Join Date: Dec 2014
Location: Netherlands
Posts: 577
Sorry to revive this thread. It was really helpful. I made below changes to the startup-sequence and my A1200 booted up.

Quote:
Originally Posted by Turran View Post
Should now look like this basically:
Code:
IF SCSIUpdate EQ 1
LoadModule Devs:scsi.device NOREBOOT
C:SetPatch SKIPROMUPDATES "scsi.device" QUIET
ELSE
C:SetPatch SKIPROMUPDATES "scsi.device" QUIET
But then I wanted to add
Code:
C:CPU FASTROM BURST
To make use of the MMU of my 1230/50 but I guess I placed it wrongly, not inside the same IF statement and I ran into the same guru loop.

Where should I put this statement in combination with the above code?

Thanks!!
spudje is offline  
 
Page generated in 0.08158 seconds with 9 queries