View Single Post
Old 06 December 2014, 22:59   #22
Posts: n/a
Originally Posted by Zippy Zapp View Post
According to the manual you can change the aspect ratio to 4:3 or Full.

According to the Specs sheet in the manual it does not support below 31Khz. Apparently that is wrong.
not suppose to but they must have programmed it for hdmi modes.
if you find monitors that support 576i mode they will work but most expect component type video connection with ypbr sync.

This one works fine other than wide and can't change aspect due to it thinks its an hdmi resolution

I have a HANNS-G that i can get picture close with rgb to component cable.
but colors are a little washed out due to combining sync with RGB lines.

Page generated in 0.03973 seconds with 10 queries