View Single Post
Old 29 November 2014, 16:50   #103
delshay
Registered User
 
Join Date: Jan 2011
Location: uk
Posts: 245
I still have my old 1438 monitor which I no longer use but it is still working, but it is fined tuned internally so that it is always centered when switching from native amiga AGA output & Graphics card.

WARNING HIGH VOLTAGE:

I found the setting on the right side of the monitor, look here & you will see 5 or 6 tiny holes where I can adjust the monitor settings, but i adjusted mine with the back cover off as its difficult to locate the adjustment with back cover on.

I used a isolated screwdriver (must be isolated due-to high voltage) inside monitor.

When switching screen between AGA & Graphics card it is always centred.

Default set-up is done by using the amiga boot menu, then switch to the same boot menu using graphics card display, no hardrive or floppy disk is loaded but private firmware in accelerator is required for graphics card to display output to monitor.

ALL MODIFICATION AT YOUR OWN RISK

Last edited by delshay; 29 November 2014 at 17:07.
delshay is offline  
 
Page generated in 0.07004 seconds with 9 queries