View Single Post
Old 06 November 2014, 05:54   #1
B14ck W01f
m68k all the way
Join Date: Aug 2011
Location: Koalaland
Posts: 485
A question about creating hardfiles


I read that the Amiga 2000HD has a SCSI hard drive, and I am creating a hardfile inside WinUAE that emulates this. I set the HD controller as SCSI unit 6, and when I used HDTools, I was able to partition the hard drive and then eventually format it using FFS. I installed WB1.3 on my main partition, while the other partition is reserved for games and applications.

Everything worked fine up until I tried to boot it using my A2000HD config. Now instead of WB booting, all I get instead is the Kickstart disk logo, as if there is no startup-sequence on the hard drive. So I'm guessing that I used the wrong unit number. So how do I know what unit number I should use?

Last edited by B14ck W01f; 06 November 2014 at 09:07.
B14ck W01f is offline  
AdSense AdSense  
Page generated in 0.08751 seconds with 9 queries