View Single Post
Old 25 September 2014, 11:50   #76

FOL's Avatar
Join Date: Nov 2006
Location: Barry / UK
Age: 39
Posts: 5,592
Send a message via MSN to FOL Send a message via Skype™ to FOL
Originally Posted by MickJT View Post
Ahh yes I forgot to mention if you want to use DOS\07, then add the latest FastFileSystem to the RDB and set that identifier when adding it. It's on the CD in System/L/

According to the research I did, SFS\02 is needed if you want large file support (especially over 4GB, although some sites mention >2GB). (back when it was called SFS2 and not part of SFS). It says "respectively" but without any reference. I think when they say over 2GB, they mean up to 4GB. Therefore SFS and SFS2 support >2GB (but <4GB) and >4GB respectively. (mentions >2GB for partitions & filesizes). I think that's just a mistake. (only mentions >4GB). Same with the readme on Aminet.

I think the readme along with this link is definitive: which explains the limits for SFS\00 and SFS\02. So it would appear SFS\00 does up to 4GB, and SFS\02 will go above that. I've edited my earlier post now.

SFS\00 is limited to a 128GB partition (but could you put a 128GB partition at the end of a 500GB drive?).

According to System/Documentation/FastFileSystem/INTRODUCTION and README, it looks like 2GB is still the filesize limit for FFS regardless of DosType.

Edit: I just noticed SYSocumentation/File_System_Table.pdf which explains all of the same stuff.
Yeh, I do remember not being able to get 1.5TB partition to work. Did my head in until I changed blocksize to 1024 and then it worked perfectly.
FOL is offline  
Page generated in 0.08925 seconds with 9 queries