View Single Post
Old 18 September 2014, 16:32   #4
Registered User
Join Date: May 2012
Location: Newcastle Upon Tyne
Posts: 40
Originally Posted by FOL View Post
Your proberly using the wrong device in HDTOOLBOX.
Ok I am now able to enable "Enable RDB Mode" As I have set the device to uae rather than IDE 0, when I clickstart everything is working I go into HD Tools and run HD Tool Box and I am able to see my drive I then goto Change Drive Type, Define New and then read configuration once it is done reading it I go to ok and then I get "Volume Install3.1 is Full" ?

Originally Posted by Toni Wilen View Post
Yes and no logs/config = no help, sorry.
I can give the config file but how do I show you my log file(s)?

Last edited by TCD; 18 September 2014 at 17:43. Reason: Back-to-back posts merged.
carvedeye is offline  
Page generated in 0.03979 seconds with 10 queries