Thread: SD card adapter
View Single Post
Old 09 September 2014, 21:50   #21
Registered User
Join Date: Aug 2004
Posts: 2,937
Originally Posted by alexh View Post
I am sure you've considered connecting your hard disk drives directly to your PC? Back in the day I had a PCI SCSI Ultra Wide card for my Windows PC with a super long data cable, didn't even take the hard drive out of my A3000, just swapped SCSI data cables.
I think it is/was possible in some circumstances to have two computers on the same SCSI bus. You need to change the SCSI ID of one of the controllers so they don't clash, and of course be careful not to access the same drive/partition from both computers at once. And also set one or both controllers not to reset the bus at power-on or reset. (So all in all, cool if you can get it to work, but getting it to work might be tricky.)
Originally Posted by alexh View Post
I also had an 8-wire PC2Amiga parallel cable and SW on the PC and the Amiga. USB parallel ports are very cheap if a good transfer rate can be achieved? No need for external power supply. Software already available with source code.
You might be out of luck using a USB parallel cable for that, but I'd love to be proved wrong. (PC-side software might try to access native parallel port hardware directly, and/or the USB cable might not support all features of the parallel port.)
mark_k is offline  
AdSense AdSense  
Page generated in 0.04155 seconds with 10 queries