View Single Post
Old 29 August 2014, 08:46   #3
Mounty
Hardware Design Engineer

Mounty's Avatar
 
Join Date: Jan 2013
Location: www.KMTech.co.uk
Posts: 372
Quote:
Originally Posted by Vot View Post
Mounty.. This is far too thick in my opinion. You should be aiming to have the case no thicker than the usb connector (maybe a few mm higher so you can have a gap between the connector and the amiga case so all usb thumb drives fit), maybe house the gotek pcb in the computer case and just put a flat ribbon through the slots in the case for the display and buttons etc. Also you could make a pcb for inside the computer to select between the gotek and the inbuilt floppy. IMHO this would add a lot more value to to your project.
Commments noted, but I don't think anyone would use a regular floppy if they had a Gotek installed. As for making the case smaller, it will be quite cramped inside there as it is.
Mounty is offline  
 
Page generated in 0.04945 seconds with 9 queries