View Single Post
Old 24 August 2014, 02:13   #46
Neil79
Registered User
Neil79's Avatar
 
Join Date: Jul 2012
Location: Kent
Age: 37
Posts: 2,454
Quote:
Originally Posted by demolition View Post
So did you try the tool as I recommended? You should be able to load it using tapdancer. Simply adjusting the screw until something loads will never yield a good result (unless you're very lucky).
It never worked bud, loaded up the tool in tapdancer and it just kept on playing with a light blue screen. I think only the once it went back to the command screen with an error.

How do I adjust something that can't even load up heh
Neil79 is offline  
 
Page generated in 0.04764 seconds with 9 queries