Thread: ACA500 tested
View Single Post
Old 02 June 2014, 15:21   #463
Photon's Avatar
Join Date: Nov 2004
Location: Hult / Sweden
Posts: 4,516
Originally Posted by freaktmp View Post
Perhaps I wasn't clear enough. This is how it goes:
Power on
First photo
Select F1 configuration
Boot to workbench without fast ram and cf aux slot
Second photo
Reset - interrupt with mouse button
Third photo
Power off

Power on
Expert configuration menu, select F5 and F8 (maprom disabled)
Boot to workbench with fast ram and cf aux slot
Fourth photo
Reset - interrupt with mouse button
Fifth photo


No, I have not saved or used saved profiles #1 and #2 (F6/F7 on the main menu)
No, I got that it was a sequence and that the settings disappeared. It's just that I've always just saved settings before rebooting. IIRC, if you actively press an F-key, it will select a profile. If you haven't saved one, it will load...well, some other settings.

But as I said, I've always just saved the config and reset. Certainly if you just set the settings and press Enter to boot, they will not be saved to Flash RAM.

It would be useful to solve this if you take a shot of the checksum hex digits that appears for these 3 steps reproduced. The first time it should be a short string, second time twice as long, third time 3 times as long.

Just thought you could get a working setup this way, by saving the settings.
Photon is offline  
Page generated in 0.03943 seconds with 10 queries