View Single Post
Old 27 May 2014, 13:23   #449
Registered User
Join Date: Aug 2013
Location: Croatia
Age: 37
Posts: 337
It should be easy to set up, I've used 3 pin plug from one old fan so I could get easily to +5V, GND and step, it'll come in handy for experiments like these


Connected it and works fine, if a bit too loud (never satisfied ). But when put inside Gotek an inside A500 I guess it will be just right. Tried with 4k6 ohm resistor and it is quieter, but I think I'll stay with 1k resistor to be on the safe side. Only thing I'm not sure of is buzzer's voltage rating. I think motherboard buzzers are 5V rated.

Last edited by Solo761; 27 May 2014 at 18:47.
Solo761 is offline  
Page generated in 0.03897 seconds with 10 queries