View Single Post
Old 24 May 2014, 17:28   #430
Alien Breeder
XDelusion's Avatar
Join Date: Mar 2011
Location: NW Ohio
Posts: 276
I installed my Gotek into an external floppy case to be used as DF1.

I had it installed internally before and configured my list, but now when I boot it as a DF1 external, when Selector.adf get to the point where it is trying to "Init DF1" it says "Cortex FE Init Effort!"

And the LEDs on the Gotek drive say "H-C".

Might I need to change a jumper on the Gotek to use it externally?

Also on a side note, every single image of WB3.1 Install Disk fails to boot with this device thus far, which in turn prevents me from being able to set up a Hard Drive from scratch with this.
XDelusion is offline  
Page generated in 0.03982 seconds with 10 queries