View Single Post
Old 08 May 2014, 22:38   #1
Registered User

Join Date: May 2014
Location: Alton, Hampshire/UK
Posts: 43
A600 only showing 1 partition in Workbench


I am trying to install Workbench onto my 4GB compact flash card and I have used WINUAE to get me started prior to fitting to a real Amiga A600.

My problem is when I use HDTools I can create a new partition (eg 3 partitions)
. I have edited the max transfer rate to 1FE00 and hit enter on all three partitions. When I start WINUAE and also the same in my real Amiga A600 I can only see the 1 partition on the Workbench. However when you go into HDTools the three partitions are visible. The 1 partition I can see is fully useable but I would like three as I want to have a Work,Stuff and Games partition, ie DH0, DH1 and DH2

Thank you
Stuart is offline  
AdSense AdSense  
Page generated in 0.04823 seconds with 9 queries