View Single Post
Old 06 May 2014, 19:52   #9
JimDrew
Registered User

 
Join Date: Dec 2013
Location: Lake Havasu City, AZ
Posts: 469
I have a problem with v2.8.0. I can select a hardfile after creating it and it works fine as long as RDB support is not enabled. If it is, it doesn't matter if it is configured as SCSI0, IDE0, or UAE, it never shows up in HDToolBox (with either uaehf.device or scsi.device). So, I make and use normal hardfiles, but I can not make or use hardfiles that are RDB based.
JimDrew is offline  
 
Page generated in 0.11679 seconds with 9 queries