can you take a pic of the bottom side of the gotek, so we can see the soldering?
also insert the jumper to DS0 until the device is flashed.
when I program my goteks, I plug all the cables from the serial device to the gotek.
then plug the usb part into the computer, start up the flasher and remove the protection bit.
I've noticed a few times I needed to unplug the serial (close the flasher) and reinsert it (leaving all the cables to the gotek connected)
starting up the flasher again.
Last edited by tomse; 19 April 2014 at 14:11.